Filter
Top Products
DES-7200 Configuration Guide Chapter 6 REUP Configuration
6-12
Meanwhile, enable all switches on the switched path to receive MAC address updating
messages, and join all ports on the switched path to the same MAC address updating
group.
In privileged mode, execute the following steps to enable the switch to receive MAC
address updating message and address updating group.
DES-7200(config)# mac-address-table
move update max-update-rate
pkts-per-second
(Optional) Configure the maximum number of
MAC address updating packets sent per
second. Range: 0-32000; default: 150.
DES-7200(config)# interface interface-id
Enter the interface configuration mode.
DES-7200(config-if)# mac-address-table
move update transit vlan vlanid
(Optional) Configure the VID for the interface
to send MAC address update message. By
default, MAC address updating message is
sent in the default VLAN of port.
DES-7200(config-if)# end
Return to privileged mode.
DES-7200# show mac-address-table
move update
Show the configuration.
DES-7200# copy running-config
startup-config
Save the configuration.
Command Function
DES-7200 # configure terminal
Enter the global configuration mode.
DES-7200 (config) # mac-address-table
move update receive
Enable the function of receiving the MAC
address updating message.
DES-7200(config)# no mac-address-table
move update receive vlan vlan-range
(Optional) Configure the VLAN range for the
device to handle MAC address updating
message. By default, MAC address updating
message is handled in all VLANs.
DES-7200(config)# interface interface-id
Etner the interface configuration mode.
DES-7200(config-if)# mac-address-table
update group [number]
Add the port to the MAC address updating
group. By default, add the port to the first
MAC address updating group.
DES-7200(config-if)# end
Return to the privileged mode.
DES-7200# show mac-address-table
update group
Show the configuration.
DES-7200# copy running-config
startup-config
Save the configuration.