Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RIP
Configuration
2-8
Command Function
DES-7200(config-if)# no ip rip receive enable
Disable the interface to receive the
RIP message.
DES-7200(config-if)# ip rip receive enable
Allow the interface to receive the RIP
message.
To disable or allow some interface to send the RIP message, execute the
following command in the interface configuration mode:
Command Function
DES-7200(config-if)# no ip rip send enable
Disable the interface to send the RIP
message.
DES-7200(config-if)# ip rip send enable
Allow the interface to send the RIP
message.
2.2.10 Configuring the Default Route Advertisement on the Interface
Use the following command to generate a default route (0.0.0.0/0) in the update
message on a specified interface in the interface configuration mode:
Command
Function
DES-7200(config-if)# ip rip
default-information originate [metric
metric-value]
Advertise the default route and other
routes.
DES-7200(config-if)# no ip rip
default-information
Cancel the default route advertisement
on the interface.
In the interface configuration mode, use the following command to generate a
default route (0.0.0.0/0) in the update message on a specified interface, and
enable only advertising this default route on this interface.
Command
Function
DES-7200(config-if)# ip rip
default-information only [metric
metric-value]
Advertise the default route only.
DES-7200(config-if)# no ip rip
default-information
Cancel the default route advertisement
on the interface.