Filter
Top Products
DES-7200 Configuration Guide Chapter 12 QinQ Configuration
12-22
l2protocol-tunnel {stp | GVRP}
tunnel-dmac mac-address
Configure the transparent transmission address
of corresponding protocl.
show l2protocol-tunnel stp
View the configuration.
An example below shows how to configure the transparent transmission address of
STP protocol:
DES-7200# configure
DES-7200(config)#l2protocol-tunnel stp tunnel-dmac 011AA9 000005
Note
The addresses available for STP protocol are 01d0f8 000005,
011AA9 000005, 010FE2 000003, 01000C CDCDD0, 01000C
CDCDD1, 01000C CDCDD2, and the addresses available for GVRP
protocol are 01d0f8 000006 and 011AA9 000006.
Without transparent transmission address configured, by default, the
last bit of the first byte of the OUI of the local device is set to 1 plus
the next three bytes (stp:000005; gvrp:000006) as multicast address.
For instance, the local device’s MAC address is 00d0f8000001, then
the transparent transmission address for STP protocol is
01d0f8000005.
12.2.7 Show QinQ
Informaiton
In the privileged mode, use the following command to show QinQ configuration.
Command Description
DES-7200# show dot1q-tunnel
Show the enablement state of dot1q-tunnel port.
DES-7200#show
interface[ intf-id ]dot1q-tunnel
Show the configuration of dot1q-tunnel port.
DES-7200# show
registration-table [ interface
intf-id ]
Show the protocol-based VID change policy
table on the dot1q-tunnle port.
DES-7200# show translation-table
[ interface intf-id ]
Show the protocol-based VID change policy
table on the Access, Trunk and Hybird ports.
DES-7200# show traffic-redirect
[ interface intf-id ]
Show the flow-based VID change policy table.