Filter
Top Products
DES-7200 Configuration Guide Chapter 5 Port-based Flow Control Configuration
5-18
Step 2: Enable storm control on all access ports.
DES-7200(config)#interface range gigabitEthernet 0/1,0/5,0/9,0/13
DES-7200(config-if-range)#storm-control broadcast
DES-7200(config-if-range)#storm-control multicast
DES-7200(config-if-range)#storm-control unicast
DES-7200(config-if-range)#exit
Step 3: Enable port security on the port directly connecting with users and bind the IP
address and MAC address
! Bind the access user: IP (1.1.1.1)/MAC (0000.0000.0001)
DES-7200(config)#interface gigabitEthernet 0/5
DES-7200(config-if-GigabitEthernet 0/5)#switchport port-security
DES-7200(config-if-GigabitEthernet 0/5)#switchport port-security
mac-address 0000.0000.0001 ip-address 1.1.1.1
DES-7200(config-if-GigabitEthernet 0/5)#exit
! Bind the access user: IP (1.1.1.2)/MAC (0000.0000.0002)
DES-7200(config)#interface gigabitEthernet 0/9
DES-7200(config-if-GigabitEthernet 0/9)#switchport port-security
DES-7200(config-if-GigabitEthernet 0/9)#switchport port-security
mac-address 0000.0000.0002 ip-address 1.1.1.2
DES-7200(config-if-GigabitEthernet 0/9)#exit
Configure Switch B
Step 1: Create the VLAN to which the switch belongs and configure port attributes.
! Create VLAN 3
DES-7200#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DES-7200(config)#vlan 3
DES-7200(config-vlan)#exit
DES-7200(config)#interface gigabitEthernet 0/5
DES-7200(config-if-GigabitEthernet 0/5)#switchport access vlan 3
DES-7200(config-if-GigabitEthernet 0/5)#exit
DES-7200(config)#interface gigabitEthernet 0/9
DES-7200(config-if-GigabitEthernet 0/9)#switchport access vlan 3
DES-7200(config-if-GigabitEthernet 0/9)#exit
DES-7200(config)#interface gigabitEthernet 0/1
DES-7200(config-if-GigabitEthernet 0/1)#switchport mode trunk
DES-7200(config-if-GigabitEthernet 0/1)#exit
Step 2: Enable storm control on all access ports.
DES-7200(config)#interface range gigabitEthernet 0/1,0/5,0/9