D-Link DES-7200 Refrigerator User Manual


  Open as PDF
of 1968
 
DES-7200 Configuration Guide Chapter 3 BFD Configuration
3-40
# Configure the BFD for static route to detect the neighbor 192.168.3.2:
DES-7200(config-if)# exit
DES-7200(config)# ip route static bfd GigabitEthernet 2/1 192.168.3.2
DES-7200(config)# ip route 192.168.2.0 255.255.255.0 GigabitEthernet 2/1
192.168.3.2
DES-7200(config)# end
2) RouterB Configuration
# Configure the Routed Port, the IP address, the BFD session parameter for
Router B:
DES-7200# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DES-7200(config)# interface GigabitEthernet2/1
DES-7200(config-if)# no switchport
DES-7200(config-if)# ip address 192.168.3.2 255.255.255.0
DES-7200(config-if)# bfd interval 50 min_rx 50 multiplier 3
# Configure the Routed Port gi1/1:
DES-7200(config-if)# exit
DES-7200(config)# interface GigabitEthernet1/1
DES-7200(config-if)# no switchport
DES-7200(config-if)# ip address 192.168.2.1 255.255.255.0
# Configure the BFD for static route to detect the neighbor 192.168.3.1:
DES-7200(config-if)# exit
DES-7200(config)# ip route static bfd GigabitEthernet 2/1 192.168.3.1
DES-7200(config)# ip route 192.168.1.0 255.255.255.0 GigabitEthernet 2/1
192.168.3.1
DES-7200(config)# end
3.4.4.4 Configuration Verification
1) View the BFD session of RouterA
DES-7200# show bfd neighbors details
OurAddr NeighAddr LD/RD RH Holdown(mult) State Int
192.168.3.1 192.168.3.2 1/2 1 532 (3 ) Up
Ge2/1
Local Diag: 0, Demand mode: 0, Poll bit: 0
MinTxInt: 200000, MinRxInt: 200000, Multiplier: 5
Received MinRxInt: 50000, Received Multiplier: 3
Holdown (hits): 600(22), Hello (hits): 200(84453)
Rx Count: 49824, Rx Interval (ms) min/max/avg: 208/440/332
Tx Count: 84488, Tx Interval (ms) min/max/avg: 152/248/196