Filter
Top Products
DES-7200 Configuration Guide Chapter 5 RERP Configuration
5-17
Step 2: Disconnect the link between Master and Transit1 (simulating that the link
between them is failed), and then verify RERP configurations on Master device; key
point: the state of primary and secondary ports.
DES-7200#show rerp
rerp state : enable
rerp admin hello interval: 1(*1s)
rerp admin fail interval : 3(*1s)
rerp local bridge : 00d0.f822.35ad
-----------------------------------
region 1
ring : 1
rerp oper hello interval : 1
rerp oper fail interval : 3
ring master : 00d0.f822.35ad
ctrl-vlan : 4000
edge-vlan :
role : master
primary-port : GigabitEthernet 4/1(down)
secondary-port : GigabitEthernet 4/2(forwarding)
Step 3: Disconnect the link between Transit1 and Backup device (simulating that the
link between them is failed), and then verify RERP configurations on Master device;
key point: the state of primary and secondary ports.
DES-7200#show rerp
rerp state : enable
rerp admin hello interval: 1(*1s)
rerp admin fail interval : 3(*1s)
rerp local bridge : 00d0.f822.35ad
-----------------------------------
region 1
ring : 1
rerp oper hello interval : 1
rerp oper fail interval : 3
ring master : 00d0.f822.35ad
ctrl-vlan : 4000
edge-vlan :
role : master
primary-port : GigabitEthernet 4/1(forwarding)
secondary-port : GigabitEthernet 4/2(forwarding)