Filter
Top Products
DES-7200 Configuration Guide Chapter 5 SPAN
Configuration
n
Session 1 is
Cautio
used to support ther global cross-linecard port mirror.
5.3.3 Deleting a Port
from the SPAN
Session
To delete a port from a SPAN session, execute the following commands:
Command Function
DES-7200(config)# no monitor session
sion_number source inte
ses rface interface-id
-
Specify the source port to delete.
interface-id: Specify corresponding interface id.
[,| ] [both | rx | tx]
You ion_number source interface
i command to delete the source p SPAN session in the
global configuration mode. The following exa
f guration.
S-7200(config)# no monitor session 1 source interface gigabitethernet 1/1
th
DES-7200(conf #
DES-7200# show mo
sess-num: 1
dest-intf:
GigabitEthernet 3/8
on
M r
can use the no monitor session sess
nterface-id ort from a
mple shows how to delete port 1
rom session 1 and verify your confi
DE
bo
ig) end
nitor session 1
5.3.4 C figuring the Flow-based
ror i
To configure the flow-based mirror, execute the following commands:
Command Function
DES-7200(co
session_num
interface-id rx
ports.
nfig)# [no] monitor session
ber source interface
acl name
Specify the matched acl name for the mirrored
flow and the mirrored source and destination
port mirror is supported.
related configuration guide.
Caution
For the ACL configuration commands, see the
Only the incoming
5-5