DES-7200 Configuration Guide Chapter 2 Basic Switch Management
Configuration
system can get remote files through TFTP only after you run the
ip command to configure the local IP address of the device used for
initiation, or otherwise TFTP transmission will fail during initiation.
Since the system needs to use the configuration of this command in the
ather than
The
boot
Caution
early stage of boot, this configuration is stored in Boot ROM r
the configuration file.
The followi figure sets the boot IP addr d designates the
network start configuration file.
D 192.168.7.11
DES-7200(config)# boot network
t t
2.16.4 Configuring Preferrab
Using
Conf
ng ess of the device an
ES-7200(config)# boot ip
ftp://192.168.7.24/config. ext
ly
the Network Start
iguration File
By default, the device preferably loads the local start configuration file specified
netw
by the boot config command. In some case, if the device needs to use the
ork start configuration file, run the service config command.
Command Function
DES-7200(Config)# service config
le the device to preferably load the start configuration
Enab
file from the remote network server.
DE
nfiguration
S-7200(Config)#no service config
Disable the device to preferably load the start co
file from the remote network server.
This ith the boot config and boot
network commands.
Whe
princ
e
loaded b
o onfig.text, the network start configuration file
cofnigured by the boot network command, and the default factory
on file is
art configuration file
mmand, the start configuration file
and, /config.text, and the default
factory configuration (null configuration).
command should use in conjunction w
n the device starts, the system loads the cofniguration file by following
iples;
If the s rvice config command is not configured, the configuration file is
y the following order-the start configuration file configured by the
nfig command, /c
boot c
configuration (null configuration).
If the service config he configurati
command is configured, t
loaded by the following order- the network st
cofnigured by the boot network co
configured by the boot config comm
2-29