Filter
Top Products
DES-7200 Configuration Guide Chapter 5 OSPF
Configuration
5-22
SwitchC#ping ipv6 3001::2
Sending 5, 100-byte ICMP Echoes to 3001::2, timeout is 2 seconds:
< press Ctrl+C to break >
！！！！！
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/10 ms
The information displayed on SwitchA and SwitchB is the same as the information
displayed on SwitchC.
5.3.2 OSPFv3 Redistribution Configuration Example
Configuration Requirements
For the connection of three devices, see the Figure-1.
Enable the OSPFv3 protocol on RouterA; Enable BGP protocol and
configure the static route on RouterC; For RouterB, redistribute the static
route on the RouterC to the OSPFv3 domain. Set the specified community
attribute for the static route redistributed to RouterC and redistribute the
specified community attribute to the OSPFv3 domain on RouterB.
Configure the external route aggregation on RouterB: aggregate the routes
within the range of 2001:db8:77::/48 and notify the aggregation to the
OSPFv3 domain.
To speed up the convergence, set the SPF calculation delay time, holdtime
and max-waittime for RouterA and RouterB as 5ms, 1000ms and 90000ms.
Figure-1 OSPFv3 Redistribution Configuration Example