Filter
Top Products
DES-7200 Configuration Guide Chapter 1 Command Line Interface
Configuration
If the command that an alias represents has more than one word, the command
will be included by the quotation marks. As shown in the following example,
configure the alias “sv” to replace the show
version command in the EXEC
er of the command line entered without
wn in the above example, the alias is invalid if you
efore the command.
-service
via DHCP
ip address
1.10 Accessing CLI
mode.
DES-7200#s?
*s=show *sv=”show version” show start-chat
start-terminal-service
An alias must begin with the first charact
any blank before it. As sho
have inputted a blank b
DES-7200# s?
show start-chat start-terminal
An alias can also be used to get the help information on obtaining command
parameters. For example, the alias “ia" represents “ip address” in the interface
configuration mode.
DES-7200(config-if)#ia ?
A.B.C.D IP address
dhcp IP Address
DES-7200(config-if)#
Here lists the parameter information after the command “ip address”, and
replaces the alias with the actual command.
An alias must be inputted fully for use. Otherwise, it can not be identified.
Use the show aliases command to view the setting of aliases in the system.
Before using CLI, you need to use a terminal or PC to connect with the network
device. Power on the network device. After the initialization of hardware and
software, you can use CLI. If the network device is used for the first time, you
can only connect the network device through the serial port (Console), which is
referred to as out-band management. In addition, you can connect and manage
the network device through Telnet virtual terminal by performing corresponding
configuraitons. In either case, you can access the command line interface.
1-9