Filter
Top Products
DES-7200 Configuration Guide Chapter 5 OSPF
Configuration
5-20
Step 2: Create OSPFv3 process and specify the router-id
SwitchC(config)#ipv6 router ospf 10
SwitchC(config-router)#router-id 3.3.3.3
Change router-id and update OSPFv3 process！ [yes/no]:y
SwitchC(config-router)#exit
Step 3: Enable OSPFv3 on interface vlan 200, with area being Area1
SwitchC (config)#interface vlan 200
SwitchC (config-if-VLAN 200)#ipv6 ospf 10 area 1
SwitchC (config-if-VLAN 200)#end
Verify configurations
Step 1: Verify whether the configurations are correct. Key points: whether
router-id is specified, whether OSPFv3 is enabled on the interface, and whether
such parameters as OSPFv3 timer are identical in the same area.
SwitchA
vlan 100
！
vlan 200
！
interface VLAN 100
no ip proxy-arp
ipv6 address 3001::1/64
ipv6 enable
ipv6 ospf 10 area 0
！
interface VLAN 200
no ip proxy-arp
ipv6 address 3001:1::1/64
ipv6 enable
ipv6 ospf 10 area 1
！
ipv6 router ospf 10
router-id 1.1.1.1
SwitchB
vlan 100
！
interface VLAN 100
no ip proxy-arp
ipv6 address 3001::2/64
ipv6 enable