Filter
Top Products
DES-7200 Configuration Guide Chapter 6 BGP
Configuration
6-44
MCE device through BGP protocol.
6.25.7 Displaying configurations
The "show" commands used in BGP MCE are similar to the "show" commands
used in ordinary BGP. The displayed information includes neighbor state, routing
information, neighbor summary and etc.
Command Function
DES-7200 # show ip vrf
Display all VRF summary information
configured on the device.
DES-7200 # show ip vrf detail
[VRF1]
Display the detailed configurations about
all VRFs or a specific VRF.
DES-7200 # show ip vrf
interfaces [VRF1]
Display the interface binding information
and state of all VRFs or a specific VRF.
DES-7200# show ip bgp vrf
VRF1 [summary| neighbors|
A.B.C.D]
Display the summary information, detailed
information, specific routing information,
and all routing information of BGP neighbor
under VRF1. Similar to those "show"
commands used in ordinary BGP, other
subcommands won't be explained herein.
DES-7200# show bgp vpnv4
unicast [all | rd rd | vrf
vrf-name] [neighbors |
summary | A.B.C.D ]
This command is similar to the above
command, but the routes displayed are
different: "all" will display all vpn routes,
"rd" will display vpn routes with a specific
RD value, and "vrf" will display vpn routes
under a specific VRF.
6.26 BGP/MPLS VPN Configuration
Please refer to the section of "BGP/MPLS L3VPN Configuration" in "MPLS
Configuration Guideline" for details.
6.27 Protocol Independent Configuration
6.27.1 route-map Configuration
The BGP protocol applies the Route-map policy on a large scale. For the
configuration of the Route-map policy, refer to the Protocol Independent
Configuration Part in this manual.