Filter
Top Products
DES-7200 Configuration Guide Chapter 5 Port-based Flow Control Configuration
5-19
DES-7200(config-if-range)#storm-control broadcast
DES-7200(config-if-range)#storm-control multicast
DES-7200(config-if-range)#storm-control unicast
DES-7200(config-if-range)#exit
Step 3: Enable port protection on all access ports.
DES-7200(config)#interface gigabitEthernet 0/5
DES-7200(config-if-GigabitEthernet 0/5)#switchport protected
DES-7200(config-if-GigabitEthernet 0/5)#exit
DES-7200(config)#interface gigabitEthernet 0/9
DES-7200(config-if-GigabitEthernet 0/9)#switchport protected
DES-7200(config-if-GigabitEthernet 0/9)#exit
5.5.5 Verification
Step 1: Check the configurations of Switch A. Key points: whether storm control has
been enabled on respective ports, whether port security has been enabled on the port
directly connecting with users and whether IP+MAC addresses have been bound
statically.
DES-7200#show running-config
vlan 2
!
interface GigabitEthernet 0/1
switchport mode trunk
storm-control broadcast
storm-control multicast
storm-control unicast
!
interface GigabitEthernet 0/5
switchport access vlan 2
switchport port-security mac-address 0000.0000.0001 ip-address 1.1.1.1
switchport port-security
storm-control broadcast
storm-control multicast
storm-control unicast
!
interface GigabitEthernet 0/9
switchport access vlan 2
switchport port-security mac-address 0000.0000.0002 ip-address 1.1.1.2
switchport port-security
storm-control broadcast
storm-control multicast
storm-control unicast
!