Filter
Top Products
DES-7200 Configuration Guide Chapter 4 DHCP Configuration
4-17
4.5.12 Configuring the
DHCP Client in the
HDLC Encapsulation
Link
DES-7200 products support obtaining the IP address dynamicaly assigned by
the DHCP server on an HDLC encapsulation interface.
To configure the DHCP client, execute the following command in the interface
configuration mode:
Command Function
DES-7200(config-if)# ip address dhcp
Obtain an IP address through DHCP.
Note
For some product in v10.1, DHCP client supports obtaining the IP
address assigned by the DHCP server in the point-to-point link of
PPP, HDLC, FR encapsulation.
4.6 Monitoring and
Maintaining Information
4.6.1 Monitoring and
Maintaining
the DHCP
Server
Three types of commands are available for monitoring and maintaining the
DHCP server:
1. Clear commands, used to clear such information as DHCP address binding,
address conflict and server statistics;
2. Debug commands, used to output necessary debugging information. Such
commands are mainly used to diagnose and fix faults;
3. Show commands, used to show information about DHCP.
DES-7200 products provide three clear commands. To clear information,
execute the following commands in the command execution mode:
Command Function
DES-7200# clear ip dhcp binding
{ address | *}
Clear the DHCP address binding
information.
DES-7200# clear ip dhcp conflict
{ address | *}
Clear the DHCP address conflict
information.