Filter
Top Products
DES-7200 Configuration Guide Chapter 3 NTP
Configuration
To disable the interface to receive the NTP message, run the following
commands in the interface configuration model:
Command Function
interface interface-type number
Enter the interface configuration mode.
ntp disable
Disable the function of receiving NTP
messages on the interface.
To enable the function of receiving NTP messages on the interface, use the
command no ntp disable in the interface configuration mode.
3.2.6 Enabling or
Disabling NTP
The no ntp command is to disable the NTP synchronization service, stop the
time synchronization, and clear relevant information of NTP configuration.
The NTP function is disabled by default, but may be enabled as long as the NTP
server is configured.
To disable the NTP, run the following commands in the global configuration
mode:
Command Function
no ntp
Disable the NTP function.
ntp authenticate or
ntp server ip-addr [version
version][ source if-name number][key
keyid][prefer]
Enable the NTP function.
3.2.7 Configuring the NTP
Real-time
Synchronization
To configure the NTP real-time synchronization, run the following commands in
the global configuration mode:
Command Function
ntp synchronization
Enable the NTP real-time
synchronization.
no ntp synchronization
Disable the NTP real-time
synchronization.
During the synchronization, the no ntp command and the no ntp
synchronization command both can stop or disable the time synchronization.
3-5