Filter
Top Products
DES-7200 Configuration Guide Chapter 5 SPAN
Configuration
1) If you change the VLAN configuration of the source port, the
configuration takes effect immediately.
2) If you cha
configuratio
nge the VLAN configuration of the destination port, the
n takes effect immediately.
3) If you have disabled the source port or destination port, the SPAN
ove the
SPAN.
5 duct Support
does not take effect.
4) If you add the source or destination port to an AP, this will rem
source port or destination port from the
.3.7 Pro
For DES-7200
one for the VL
belongs and the packets a
series, if the vid for the tagged packet is inconsistent with the
AN to which the switch interface(take the interface A for example)
re sent to the interface A, the packets will not be
forwarded or mirrored to the destination port.
IGMP Snooping function is enabled, the IGMP protocol
message rrored to the designated port and the unknown multicast
packets c d neither.
For DES-7200 series, if the mirrored destination port is congested(for example,
ination port monitors a 1000Mbps source port), the Pause
frames are sent from the source port.
For DES-72 ackets sent
from the CP
By default, other po ckets to the
mirrore t learn the
address but it send orts to send
the packets t d destination
port to lear stination port
switching.
For DES-72 rt, the packets
on the mirrored de
For DES-72
packets on the mirrored destination port are the multicast packets before being
routed.
For DES-7200 series, the functions of mirror and IPFIX sampling cannot be
configured at the same direction on the same port simultaneously, but can be
configured at different directions on the same port simultaneously. For example,
the input mirror and input sampling or the output mirror and output sampling
For DES-7200 series, if
s cannot be mi
an not be mirrore
a 100Mbps dest
00 series, if the STP has not been enabled, the BPDU p
U can not be mirrored to the destination port.
rts on the DES-7200 series can not send the pa
d destination port. The mirrored destination port can no
s the packets to other ports. To allow the other p
o the mirrored destination port and make the mirrore
n the address, you can configure the mirrored de
00 series, if the mirrored source port is the route po
stination port are tag packets.
00 series, with the multicast routing packets mirrored
, the output
5-7