Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Configuring BGP IP VPN
2-90
DES-7200(config)# mpls router ldp
DES-7200(config-mpls-router)# ldp router-id interface loopback 0 force
DES-7200(config-mpls-router)# exit
DES-7200(config)# interface gigabitethernet 1/0
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-GigabitEthernet 1/0)# no switchport
DES-7200(config-if-GigabitEthernet 1/0)# ip address 172.168.10.2 255.255.255.0
DES-7200(config-if-GigabitEthernet 1/0)# label-switching
DES-7200(config-if-GigabitEthernet 1/0)# mpls ip
DES-7200(config-if-GigabitEthernet 1/0)# exit
DES-7200(config)# interface gigabitethernet 1/1
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-GigabitEthernet 1/1)# no switchport
DES-7200(config-if-GigabitEthernet 1/1)# ip address 172.168.20.1 255.255.255.0
DES-7200(config-if-GigabitEthernet 1/1)# label-switching
DES-7200(config-if-GigabitEthernet 1/1)# mpls ip
DES-7200(config-if-GigabitEthernet 1/0)# end
# Configure routing protocols on the backbone network.
DES-7200# configure terminal
DES-7200(config)# router ospf 1
DES-7200(config-router)# network 172.168.10.0 0.0.0.255 area 0
DES-7200(config-router)# network 172.168.20.0 0.0.0.255 area 0
DES-7200(config-router)# end
P2:
The configuration procedure is similar to that of P1.
For the protocol between PEs and CEs, you can choose EBGP, OSPF, RIP, or other routing
protocol as required.