Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RMON
Configuration
The subgroup History Control is used to set such control information as
sampling interval and sampling data source.
The subgroup Ethernet History provide
s history data about the network section
ages, broadcast packets, utilization, number of collision and
atistics for the administrator.
2
traffic, error mess
other st
.1.3 Alarm
Alarm is the third group in RMON. It monitors a specific management
information base (MIB) object at the specified interval. When the value of this
MIB object is higher than the predefined upper limit or lower than the predefin
ed
m arm will be triggered. The alarm is handled as an event by
g the log or sending the SNMP Trap message.
2
lower li it, an al
means of recordin
.1.4 Event
Event is the ninth group
SNMP Trap message wh
in RMON. It determines to generate a log entry or a
en an event is generated due to alarms.
2.2 RMON Configuration
Tas
k List
2
Statistics
.2.1 Configuring
O d a statistic entry. ne of these commands can be used to ad
Command Function
DES-7200(config-if)# rmon collection stats
index
[owner ownername]
Add a statistic entry.
DES-7200(config-if)# no rmon collection stats
index
Remove a statistic entry.
The current version of DES-7200 product supports only the statistics of
Caution
Ethernet interface. The index value should be an integer between 1 to 65535.
At present, at most 100 statistic entries can be configured at the same time.
2
History
.2.2 Configuring
One of these commands can be used to add a history entry.
2-2