Filter
Top Products
DES-7200 Configuration Guide Chapter 4 SNTP
Configuration
4.2.1 Default
Configuration
B TP configurations are a : y default, the SN s follows
Function Default
SNTP state Disabled.
IP address for the NTP server 0.
SNTP Sync Interval 1800s
Local Time-zone GMT+8
4.2.2 Enabling SNTP
To enable the SNTP, run the following c the global configuration
mode:
ommands in
Command Function
DES-720
Enable the SNTP and synchronize the time once
immediately. (in order to prevent frequent time
synchronization, the sync-interval must not be less
than 5s.)
0(config)# sntp enable
To disable the SNTP, use the no sntp enable command.
4.2.3 Configuring the
IP address for
the NTP server
The SNTP Client is totally compatible with the NTP Server due to the
inconsistency of SNTP and N
TP messages. There are many NTP servers in the
network, you can choose one switch with less latency as the NTP server.
For the detailed NTP server ip addresses, please logon to
http://www.tim http:/
192.43.2 8(time.nist.gov).
SNTP server, run the following commands in the
global co e:
e.edu.cn/ or
44.1
/www.ntp.org/. For example,
To set the IP address for the
nfiguration mod
Command Function
DES-7200(config)# sntp server
ip-address
Specify the IP address for the SNTP serve
r.
4-3