Filter
Top Products
DES-7200 Configuration Guide Chapter 5 SPAN
Configuration
5.3.1
C
Default SPAN
no figuration
Function Default Configuration
SPAN status Disabled
5.3.2 a SPAN Session
and Specifying the
nitored Port
Creating
Monitoring Port and
Mo
T the de
execute the f
o set up a SPAN session and sepcify
ollowing commands.
stination port and the source port,
Command Function
DES-7200(config)# monitor session
session_number source interface interface-id
[,| -] {both | rx | tx}
Specify the source port.
interface-id: Specify corresponding inte
rface id.
DES-7200(config)# monitor session
Specify the destination port.
ination interface
interface-id: Specify corresponding interface id.
The switch parameter supports exchange on the
mirrored destination port.
session_number dest
interface-id [switch]
To delete a SPAN session, use the no monitor session session_number
mmand in the global configuration mode. To delete all the SPAN sessions,
use the no monitor session all command in the global configuration mode.
session_number source interface
interface nd or the no monitor session session_number destination
interface interface-id command to delete the source port or destination port in
T g example shows how to cre on 1. First, clear the
configuration of sessio
Sho
D onitor session 1
DES-7200(config)# monitor session 1 source interface gigabitEthernet 3/1 both
ES-7200(config)# monitor session 1 destination interface gigabitEthernet 3/8
ES-7200(config)# end
show monitor session 1
G r
dest-intf:
GigabitEthernet 3/8
co
You can use the no monitor session
-id comma
the global configuration mode.
he followin ate sessi
n 1, and then mirror the
w monitor session command allows you
ES-7200(config)# no m
frames from port 1 to port 8. The
to verify your configuration.
D
D
DES-7200#
sess-num: 1
src-intf:
igabitEthe net 3/1 frame-type Both
5-4