Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Configuring BGP IP VPN
2-109
DES-7200(config)# mpls router ldp
DES-7200(config-mpls-router)# ldp router-id interface loopback 0 force
DES-7200(config-mpls-router)# advertise-labels for bgp-routes acl 102
DES-7200(config-mpls-router)# exit
DES-7200(config)# interface gigabitethernet 1/1
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-Gigabitethernet 1/1)# no switchport
DES-7200(config-if-Gigabitethernet 1/1)# ip address 10.10.10.2 255.255.255.0
DES-7200(config-if-Gigabitethernet 1/1)# label-switching
DES-7200(config-if-Gigabitethernet 1/1)# mpls ip
DES-7200(config-if-Gigabitethernet 1/1)# end
# Configure a routing protocol on the backbone network to redistribute only BGP routes that
match the route map rules (The route map rules are optional and allow you to reduce the number
of unnecessary routes).
DES-7200# configure terminal
DES-7200(config)# router ospf 10
DES-7200(config-router)# network 10.10.10.0 0.0.0.255 area 0
DES-7200(config-router)# network 3.3.3.3 0.0.0.0 area 0
DES-7200(config-router)# redisteibute bgp subnets route-map external-pe-route
DES-7200(config-router)# end
# Assign an IP address to the interface connected to ASBR2.
DES-7200(config)# interface gigabitethernet 1/0
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-GigabitEthernet 1/0)# no switchport
DES-7200(config-if-gigabitethernet 1/0)# ip address 30.30.30.1
255.255.255.0
# Enable label switching on an interface.
DES-7200(config-if-gigabitethernet 1/0)# label-switching
The configuration of ASBR2 is similar to that of ASBR1.