Filter
Top Products
DES-7200 Configuration Guide Chapter 6 RSPAN
Configuration
Command Function
DES-7200(config)# monitor session
session_num destination remote
vlan remote_vlan-id [reflector-port]
interface interface-name [switch]
.
on
Configure Remote VLAN and reflector port
The reflector port should join the Remote
VLAN.
The Switch keywork indicates the destinati
port joins switching.
Product
support
For DES-7200 series, eac
h session supports one reflector port.
Note
recommended to set the p
disable other configuration
The reflector port needs to mote VLAN.
The reflector port cannot forward traffic as normal port. It is
ort in down state as reflector port and
s
join the Re
on it.
6.2.2.7 Configuration Steps
Configure the source sw ing steps: itch by the follow
Command Function
DES-72 te00# configure rminal
Enter the global configuration mode.
DES-7200(config)# vl n a vlan-id
Enter the VLAN configuration mode.
nfig-Vlan)# remote-span
Set the VLAN as the remote SPAN VLAN.
DES-7200(co
DES-7200(config-Vlan)# exit
Return to the global configuration mode.
DES-7200(config)# mo
session_num remote-so
Configure the remote mirroring source.
nitor session
urce
DES-7200(config)# monitor session
interface
me [rx | tx | both]
Configure the remote mirrored source port
(rx and tx of the source port can be set to
the same or different destination port; but
each of them can be configured with one
destination port only. )
session-num source
interface-na
6-6