Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Configuring BGP IP VPN
2-113
DES-7200(config-router)# neighbor 30.30.30.2 remote-as 2
DES-7200(config-router)# neighbor 1.1.1.1 remote-as 1
DES-7200(config-router)# neighbor 1.1.1.1 update-source loopback 0
DES-7200(config-router)# address-family ipv4
DES-7200(config-router-af)# neighbor 30.30.30.2 send-label
DES-7200(config-router-af)# neighbor 30.30.30.2 route-map internal-mpls-route out
DES-7200(config-router-af)# neighbor 1.1.1.1 send-label
DES-7200(config-router-af)# neighbor 1.1.1.1 route-map external-mpls-route out
DES-7200(config-router-af)# network 1.1.1.1 mask 255.255.255.255
DES-7200(config-router-af)# end
# Configure MPLS signaling and enable MPLS on an interface.
DES-7200# configure terminal
DES-7200(config)# mpls ip
DES-7200(config)# mpls router ldp
DES-7200(config-mpls-router)# ldp router-id interface loopback 0 force
DES-7200(config-mpls-router)# exit
DES-7200(config)# interface gigabitethernet 1/1
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-Gigabitethernet 1/1)# no switchport
DES-7200(config-if-Gigabitethernet 1/1)# ip address 10.10.10.2
255.255.255.0
DES-7200(config-if-Gigabitethernet 1/1)# label-switching
DES-7200(config-if-Gigabitethernet 1/1)# mpls ip
DES-7200(config-if-Gigabitethernet 1/1)# end
# Run OSPF on the backbone network to transmit routing information.
DES-7200# configure terminal
DES-7200(config)# router ospf 10
DES-7200(config-router)# network 10.10.10.0 255.255.255.0 area 0
DES-7200(config-router)# network 3.3.3.3 0.0.0.0 area 0
DES-7200(config-router)# end
# Assign an IP address to the interface connected to ASBR2.
DES-7200(config)# interface gigabitethernet 1/0
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.