Filter
Top Products
DES-7200 Configuration Guide Chapter 3 IPv6 Tunnel Configuration
3-6
Command Meaning
tunnel mode ipv6ip
isatap
Set the tunnel type to ISATAP tunnel.
ipv6 address
ipv6-prefix/prefix-length eui-64
Configure the IPv6 ISATAP address. Be sure to
specify to use the eui-64 keyword. In this way, the
ISATAP address will be automatically generated.
The address configured on an ISATAP interface
must be an ISATAP address.
tunnel source type num
Specify the source interface number referenced by
a tunnel. On the referenced interface, the IPv4
address must have been configured.
no ipv6 nd suppress-ra
By default, it is disabled to send router
advertisement messages on an interface. Use the
command to enable the function, allowing the
ISATAP host to be automatically configured.
End
Return to the privileged EXEC mode.
copy running-config
startup-config
Save the configuration.
Refer to the section Verifying and Mmonitoring IPv6 Tunnel Configuration to check the
operation of the tunnel.
3.3 Verifying and
Monitoring IPv6 Tunnel
Configuration
This section introduces how to verify the configuration and operation of an IPv6 tunnel.
Brief steps
enable
show interface tunnel number
show ipv6 interface tunnel mumber
ping protocol destination
show ip route
show ipv6 route
To verify the configuration and operation of a tunnel, execute the following commands
in the privileged mode:
Command Meaning
enable
Enter the privileged configuration mode.