Filter
Top Products
DES-7200 Configuration Guide Chapter 5 POE Management Configuration
5-2
5.2.1 Remote power supply
configuration
The switch supporting POE can automatically detect whether the device connected to
a port is a standard PD device and supply power to the standard PD device.
You can enable or turn off the remote power supply of a port, set the minimum allowed
wed voltage of the POE system, set
the power management mode of the switch, and set the disconnection detection mode
by using the com
Table-1: Remot wer Supply Configuration
voltage of the POE system, set the maximum allo
mand line.
e Po
Device Configuration Default Description
Enable/disable the PoE of the
Disabled -
port
Set the maximum power of the
15.4w -
power supply for the port
Set the minimum allowed
45v -
voltage of the POE system
Set the maximum allowed
voltage of the POE system
57v -
Power management mode o
the switch
f
to
Au -
Switches
supporting
PoE
Disconnection detection mode AC -
PD device
Correct connection
with the
electrical interface of the POE
device
- -
5.2.2 Enabling/Disabling the PoE
of the Port
You can enable or disable the PoE feature of a port as needed by using the following
commands. By default, the PoE is disabled. Please do the following configuration in
th al m
T E ature of a
e glob ode.
able-2: nable/Disable the PoE Fe Port
Step 1
Configure
Enter the configuration mode
Step 2
interface gigabitEthernet
Select the port, enter the interface
e
ured.
interface-id
configuration mode, and specify th
physical port to be config