Filter
Top Products
DES-7200 Configuration Guide Chapter 2 IPv6 Configuration
2-17
To enable redirection on the interface, execute the following commands in the global
configuration mode:
Command Meaning
DES-7200#configure terminal
Enter the global configuration mode.
DES-7200(config)#interface
interface-id
Enter the interface configuration mode.
Note that the no switchport command shall be
used to switchover the layer-2 port to the layer-3
interface.
DES-7200(config-if)#ipv6 redirects
Enable the IPv6 redirection function.
DES-7200(config-if)#end
Return to the privileged EXEC mode.
DES-7200#show ipv6 interface
interface-id
Show the interface configuration.
DES-7200#copy running-config
startup-config
Save the configuration.
Use the no ipv6 redirects command to disable the redirection function. The following
is an example to configure the redirection function:
DES-7200(config)# interface vlan 1
DES-7200 (config-if)# ipv6 redirects
DES-7200 (config-if)# end
DES-7200 # show ipv6 interface vlan 1
Interface vlan 1 is Up, ifindex: 2001
address(es):
Mac Address: 00:d0:f8:00:00:01
INET6: fe80::2d0:f8ff:fe00:1 , subnet is fe80::/64
INET6: fec0:0:0:1::1 , subnet is fec0:0:0:1::/64
Joined group address(es):
ff01:1::1
ff02:1::1
ff02:1::2
ff02:1::1:ff00:1
MTU is 1500 bytes
ICMP error messages limited to one every 10 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds