Filter
Top Products
DES-7200 Configuration Guide Chapter 7 RLDP Configuration
7-12
Step 3: Restore RLDP detection on the port.
! Execute "rldp reset" command on Switch A.
SwitchA#rldp reset
! Configurations of Switch B are the same as above.
7.4.1.5 Verify Configurations
Display RLDP information about all ports on the device.
! RLDP information of all ports on Switch A
SwitchA#show rldp
rldp state : enable
rldp hello interval: 3
rldp max hello : 2
rldp local bridge : 00d0.f822.33aa
-----------------------------------
Interface GigabitEthernet 0/2
port state : normal
neighbor bridge : 00d0.f800.41b0
neighbor port : GigabitEthernet 0/3
unidirection detect information:
action: warning
state : normal
Interface GigabitEthernet 0/1
port state : normal
neighbor bridge : 0000.0000.0000
neighbor port :
loop detect information :
action: block
state : normal
! RLDP information of all ports on Switch B
SwitchB#show rldp
rldp state : enable
rldp hello interval: 3
rldp max hello : 2
rldp local bridge : 00d0.f800.41b0
-----------------------------------
Interface GigabitEthernet 0/3
port state : normal
neighbor bridge : 00d0.f822.33aa