Filter
Top Products
DES-7200 Configuration Guide Chapter 4 MLD
Configuration
4-11
static command.
Run the following command in the global configuration mode:
Command Function
DES-7200(config)# ipv6 mld
ssm-map enable
Enable the ssm-map function.
Use the no ipv6 mld ssm-map enable command to disable the SSM-MAP
function.
4.2.17 Configure MLD SSM-MAP Static
Use this command together with the ipv6 mld ssm-map enable command. After
configuring this command, the MLDv1 messages received will be mapped to the
corresponding source records.
Run the following command in the global configuration mode:
Command Function
DES-7200(config）# ipv6 mld
ssm-map static acl_name
src_address
Map all group records complying with
acl_name to the source address of
src_address.
Use the no ipv6 mld ssm-map static command to cancel the mapping
relationship between related group record and source address.
4.3 Monitor and Maintain MLD State and Listener
Information
4.3.1 Clear the dynamic listener information in the MLD cache
Use this comamnd to clear the dynamic listener information in the MLD cache.
Note that this command cannot delete the statically added listener information.
Run the following command in the privilege mode:
Command Function
DES-7200# clear ipv6 mld group
[group-address ] [interface-type
interface-number]
Clear all dynamic listener information
in the MLD cache learned from
response message.
Clear all mld group information if there
is no parameter.
4.3.2 Clear all information in MLD cache on the specific interface
To clear all information in MLD cache on the specific interface, run the following
command in the privilege mode:
Command Function
DES-7200# clear ipv6 mld
interface
interface-type
Clear all information in MLD cache on
the interface.