Filter
Top Products
DES-7200 Configuration Guide Chapter 12 NFPP Configuration
12-76
Or to delete one trusted host:
DES-7200(config-nfpp)# no trusted-host 1.1.1.1 255.255.255.255
Caution
When match rule is not configured, the following prompting
message will be displayed: "%ERROR: Please configure
match rule first."
While adding an IPv4 trusted host but the etype of match rule
is not IPv4, the following prompting message will be
displayed: "%ERROR: Match type can't support IPv4 trusted
host."
While adding an IPv6 trusted host but the etype of match rule
is not IPv6, the following prompting message will be
displayed: "%ERROR: Match type can't support IPv6 trusted
host."
When the table of trusted hosts is full, the following
prompting message will be displayed: "％ERROR: Attempt
to exceed limit of 500 trusted hosts.".
When the table of monitored hosts contains an entry
matching a trusted host (with same IP address), the system
will automatically delete the corresponding entry of this IP
address.
When it is failed to delete a trusted host, the following
prompting message will be displayed "％ERROR: Failed to
delete trusted host 1.1.1.0 255.255.255.0 (the trusted host
configured)."
When it is failed to add a trusted host, the following
prompting message will be displayed "％ERROR: Failed to
add trusted host 1.1.1.0 255.255.255.0 (the trusted host
configured)."
When a trusted host to be added exists already, the following
prompting message will be displayed "％ERROR: Trusted
host 1.1.1.0 255.255.255.0 (the trusted host configured) has
already been configured."
When a trusted host to be deleted doesn't exist, the following
prompting message will be displayed "％ERROR: Trusted
host 1.1.1.0 255.255.255.0 (the trusted host configured) is
not found."
When it is unable to allocate memory for a trusted host, the
following message will be displayed "％ERROR: Failed to
allocate memory."