Filter
Top Products
DES-7200 Configuration Guide Chapter 6 Syslog Configuration
6-4
6.2.4 Enabling Switches in Log
System
By default, the system name is not included information. To add or remove
th on, perfo al
configuration mode.
in the log
e system name in the log informati rm the following commands in the glob
Command Function
DES-7200(config)# no service sysname
Cancel the system name in the log
message.
DES-7200(config)# service sysname
stem name to the log message.
Add the sy
6.2.5 Enabling Log Statistics
B n is disabl g statistics
function, perform the following commands in the global configuration mode.
y default, the log statistics functio ed. To enable or disable the lo
Command Function
DES-7200(config)# no logging count
Disable the log statistics function and delete
the statistics information
DES-7200(config)# logging count
Enable the log statistics function
6.2.6
Number Switch of Log
Informatio
Enabling the Sequential
n
B rmation has no sequen r. To add or delete sequential
n mation, run the followin figuration
m
y default, the log info tial numbe
umber in log infor
ode:
g command in the global con
Command Function
DES-7200(config)# no service
sequence-numbers
Delete sequential number in the log
messages
DES-7200(config)# service
Add sequential number to the log
sequence-numbers
messages
6.2.7
B r Input and
Output
Configuring Synchronization
etween Use Log
B synchronous with log output. User input is interrupted if the
log is output when the user is keying in characters. Use this command to configure
synchronization between user input and log output in the line configuration mode:
y default, user input is a