Filter
Top Products
DES-7200 Configuration Guide Chapter 6 RSPAN
Configuration
DES-7200(config)#monitor session
ote vlan
remote_vlan-id [reflector-port] interface
Configure Remote
e
eflector
port for DES-7200 series. The output
ns
switching.
session_num destination rem
interface-name [switch]
VLAN and reflector port.
The reflector port should join the remot
VLAN.
It is unnecessary to configure the R
destination portis mandatory.
switch indicates the destination port joi
DES-7200(config)# monitor session
rface
Set theACL for the streams to be mirrored.
session_number source inte
interface-id rx acl name
Caution
z In a RSPAN session, if the middle switch uses the port
of non-E series line cards as forwarding port, only RX or
TX mirroring can be configured on the source sw
z It is not recommended to add common ports to
nected to the middle
itch or the destination switch to be the mirrored source
port, or otherwise it will may cause flow confusion in the
itch. And
Remote VLAN.
z Do not set the port that is con
sw
network.
if alternative configuration of TX mirroring and RX
mirroring is executed on the source switch, you should
clear the MAC address of Remote VLAN on the middle
switch.
6.2.3 Configuring the Middle
Switch
In a RSPAN session, the middle switch ensures transparnet transmission of mirrored
pa N.
ckets in a VLA
Command Function
DES-7200# configure terminal En ter the global configuration mode.
DES-7200(config)# vlan vlan-id
Enter the VLAN configuration mode.
6-7