DES-7200 Configuration Guide Chapter 5 RERP Configuration
5-11
Command Function
DES-7200# show rerp
View the RERP configuration and status of the
device
In the example below, the show rerp command is used to view the RERP
configuration and status of the device.
DES-7200# show rerp
rerp state : enable
rerp admin hello interval : 1(*1s)
rerp admin fail interval : 3(*1s)
rerp edge interval : 1(*300 ms)
rerp local bridge : 001a.a902.fe0b
-----------------------------------
region 1
ring : 1
rerp oper hello interval : 1
rerp oper fail interval : 3
ring master : 001a.a902.fe0b
ctrl-vlan : 100
edge-vlan :
role : master
primary-port : GigabitEthernet 0/4(forwarding)
secondary-port : GigabitEthernet 0/21(down)
5.3.2 Viewing RERP Packet
Statistics
In the privileged mode, run the following command to view the RERP packet statistics:
Command Function
DES-7200# show rerp statistics region
num ring ring_id
View the RERP packet statistics
DES-7200# clear rerp statistics
Clear the RERP packet statistics