Filter
Top Products
DES-7200 Configuration Guide Chapter 3 BFD Configuration
3-28
Command Function
show bfd neighbors [vrf vrf-name]
[ipv4 ip-addess [details]| ipv6
ipv6-addess [details] |client
{bgp|ospf|rip|vrrp|static-route|pbr}
[ipv4 ip-addess [details] | ipv6
ipv6-addess [details]| details]]
Show the BFD session information. For
details, see the field description in Table-1.
show vrrp Show the configuration of BFD for VRRP.
show route-map Show the configuration of BFD for PBR.
show ip static route
Show the configuration of BFD for static
route.
show ip bgp neighbors Show the configuration of BFD for BGP.
show ip ospf Show the configuration of BFD for OSPF.
show ip rip database Show the configuration of BFD for RIP.
Cautio
n
The displaying commands above can be configured in any
configuration mode except for the user mode.
3.4 Configuration Examples
3.4.1 Example of Configuring BFD
for RIP
3.4.1.1 Network Requirement
RouterA and RouterB are interconnected through a L2 switch. Both routers
run the RIP protocol and enable the BFD for RIP on the interface. After a link
failure between RouterB and L2 switch occurs, BFD detects the failure and
notifies the RIP of the failure, triggering the rapid convergence.