Filter
Top Products
DES-7200 Configuration Guide Chapter 3 BFD Configuration
3-29
3.4.1.2 Network Topology
Figure-4 Topology of Configuring BFD for RIP
3.4.1.3 Configuration Steps
1) RouterA Configuration
# Configure the Routed Port gi 2/1, the IP address, the BFD session
parameter for Router A:
DES-7200# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DES-7200(config)# interface GigabitEthernet2/1
DES-7200(config-if)# no switchport
DES-7200(config-if)# ip address 192.168.3.1 255.255.255.0
DES-7200(config-if)# bfd interval 200 min_rx 200 multiplier 5
# Configure the Routed Port gi1/1:
DES-7200(config-if)# exit
DES-7200(config)# interface GigabitEthernet1/1
DES-7200(config-if)# no switchport
DES-7200(config-if)# ip address 192.168.1.1 255.255.255.0
# Enable RIP and configure the BFD for RIP to detect the neighbor
192.168.3.2:
DES-7200(config-if)# exit
DES-7200(config)# router rip
DES-7200(config-router)# version 2
DES-7200(config-router)# network 192.168.3.0
DES-7200(config-router)# network 192.168.1.0
DES-7200(config-router)# passive-interface GigabitEthernet 2/1
DES-7200(config-router)# bfd all-interfaces
2) RouterB Configuration
# Configure the Routed Port, the IP address, the BFD session parameter for
Router B:
DES-7200# configure terminal