Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RIP
Configuration
2-17
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default
Gateway of last resort is no set
C 110.11.2.0/24 is directly connected, GigabitEthernet 0/1
C 110.11.2.2/32 is local host.
R 155.10.1.0/24 [120/1] via 110.11.2.1, 00:15:21, GigabitEthernet 0/1
C 196.38.165.0/24 is directly connected, GigabitEthernet 0/2
C 196.38.165.1/32 is local host.
R 117.102.0.0/16 [120/1] via 110.11.2.2, 00:00:47, GigabitEthernet 0/1
3. View routing table on Switch C, as shown below (the bold figures are the
routing information learned through RIP):
DES-7200#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default
Gateway of last resort is no set
C 110.11.2.0/24 is directly connected, GigabitEthernet 0/1
C 110.11.2.3/32 is local host.
C 117.102.0.0/16 is directly connected, GigabitEthernet 0/2
C 117.102.0.1/32 is local host.
R 155.10.1.0/24 [120/1] via 110.11.2.1, 00:20:55, GigabitEthernet 0/1
R 196.38.165.0/24 [120/1] via 110.11.2.3, 00:19:18, GigabitEthernet 0/1
2.3.2 RIP Split Horizon
Network Topology
Figure 2 Topological diagram for R
IP split horizon
Networking Requirements
There are two devices on the network. Switch A is configured with a secondary