Filter
Top Products
DES-7200 Configuration Guide Chapter 2 QoS Configuration
2-11
Command Description
Interface interface
Enter the interface configuration mode.
[no] service-policy {input |
output policy-map-name}
Apply the created policy map to the interface,
where the policy-map-name is the name of the
created policy map, input is the input rate limit and
output is the output rate limit.
Note
DES-7200 series support applying the policy map to the out direction
only for 24sfp or 48gt/4sfp_poeII linecard. Because it is necessary to
associate the class map with acl, all restrictions of the acl configuration
are applicable for the qos configuration. For the details, see the ACL
Configuration.
For DES-7200 series, with the AP applied to the police, the configured
bandwidth limit can be shared by all AP members if the AP member
port address the following requirements:
a) if the number of ports of the linecard or device is less than 48 ports,
all Aggregate Port members must on the linecard or the device
port.
b) If the number of ports of the linecard or device is equal to or more
than 48 ports, all Aggregate Port members must on the linecard or
the former 24 ports or latter 24 ports on the device.
2.2.8 Applying Policy Maps to the
Logic Interface Group
To apply Policy Maps to the logic interface group, run the following commands:
Command Description
DES-7200#configure terminal
Enter the configuration mode
DES-7200(config)#virtual-group
virtual-group-number
Enter the logic interface group configuration
mode.
DES-7200(config)# [no]
service-policy {input | output}
policy-map-name
Apply the created Policy Maps to the logic
interface group.
policy-map-name: the name of created policy
map;
input: the input rate-limit;
output: the output rate-limit.