Filter
Top Products
DES-7200 Configuration Guide Chapter 5 Port-based Flow Control Configuration
5-22
5.6.2 Default Configurations to
Limit the Number of Access
IPs on the Port
The following table shows the default configurations to limit the number of access IPs
on the port
Function Default setting
Limiting the number of access IPs on the port
This feature is disabled on all ports. The
default value is 0.
5.6.3 Configuring the Maximum
Number of Access IPs on the
Port
In privileged mode, configure the maximum number of access IPs on the port:
Command Function
DES-7200# configure Enter configuration mode
DES-7200(config)#interface
interface-id
Enter interface mode
DES-7200(config-if)#nac-author-user
maximum value
Configure the maximum number of access IPs on
the port
DES-7200(config-if)#no
nac-author-user maximum
Disable the maximum number of access IPs on the
port
5.6.4 Displaying the Number of
Access IPs on the Port
You can view the maximum number of access IPs configured on the port and the
number of IP address bindings:
Command Function
DES-7200#show nac-author-user
Display the maximum number of access IPs on the
port and the number of IP address bindings.
As shown below:
DES-7200#show nac-author-user
Port Cur_num Max_num
-------- ------- -------
Fa0/1 2 50