Filter
Top Products
DES-7200 Configuration Guide Chapter 12 QinQ Configuration
12-21
12.2.6.2 Configuring Transparent
Transmission of GVRP
Protocol Packets
In the privileged mode, you can configure transparent transmission of GRVP protocol
packets by the following steps:
Command Description
configure terminal
Enter the global configuration mode.
l2protocol-tunnel gvrp
Configure to enable transparent
transmission of GRVP protocol packets
globally.
interface interface-id
Enter the interface configuration mode.
l2protocol-tunnel gvrp enable
Enable transparent transmission of GRVP
protocol packets on the interface.
show l2protocol-tunnel gvrp
View the configuration.
An example below shows how to enable transparent transmission of GVRP protocol
packets:
DES-7200# configure
DES-7200(config)# l2protocol-tunnel gvrp
DES-7200(config)# interface fa 0/1
DES-7200(config-if)# l2protocol-tunnel gvrp enable
Note
Enabling transparent transmission on the interface takes effect only
after this function is enabled globally. Once enabled, the interface
does not join the protocol computation. If the packets received are
destined to special multicast address, this implies that there is
something wrong in the network and thus the packets are directly
dropped.
12.2.6.3 Configuring Transparent
Transmission Address
In the privileged mode, you can configure transparent transmission address by the
following steps:
Command Description
configure terminal
Enter the global configuration mode.