Filter
Top Products
DES-7200 Configuration Guide Chapter 5 OSPF
Configuration
5-16
5.2.13 Configuring the OSPFv3 BFD
For the detailed OSPFv3 BFD configurations, refer to the chapter of BFD
Configuration.
5.2.14 Debugging and Monitoring OSPFv3
The OSPFv3 process supports plenty of debug commands and monitoring
commands.
5.2.14.1 OSPFv3 Debugging Command
To debug OSPFv3, execute the following commands in the privileged
configuration mode:
Command Function
debug ipv6 ospf events
Show the OSPFv3 event information.
debug ipv6 ospf ifsm
Show the state machine events and changes of the
outbounding interface.
debug ipv6 ospf lsa
Show the related OSPFv3 LSA information.
debug ipv6 ospf nfsm
Show state machine events and changes of
neighbor.
debug ipv6 ospf nsm
Show the OSPFv3 NSM module related information.
debug ipv6 ospf packet
Show the OSPFv3 packet information.
debug ipv6 ospf route
Show the OSPF routing calculation and addition
information.
Use the above undebug commands to disable the above enabled debug
commands.
Caution
The debug commands are provided for technicians.
Running a debug command will affect the performance of the system in a
certain extent. Therefore, after running debug commands, be sure to use
undebug commands to protect the performance of the system.
5.2.14.2 OSPFv3 Monitoring Command
To monitor OSPFv3, execute the following commands in the privileged
configuration mode:
Command Function
show ipv6 ospf
Show the information of the OSPFv3