Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Basic Switch Management
Configuration
Command Purpose
Set the privileged lev
DES-7200(config)# privilege mode [all]
all – Change th
{level level | reset} command-string
the specified c
el for a command.
mode – The CLI command mode at which you are
example, config
indicates the global configuration mode, exec
indicates the privileged command mode, and interface
rface configuration mode.
e privileges of all the sub-commands of
ommands into the same level.
level level – Authorization level in the range from 0 to
el 15 is for
an switch over between
various levels by using the enable/disable command.
g - The command to be authorized.
authorizing the command. For
indicates the inte
15. Level 1 is for the normal user level. Lev
the privileged user level. You c
command-strin
To restore the configuration for a specified command, use the no privilege
ommand in the global configuration mode.
2.2.4.2 Exa
Authori
mode [all] level level c
mple of Command
zation Configuration
The fol
its sub-com
lowing is the configuration process that sets the reload command and all
mands to be level 1, and brings level 1 into effective (by setting the
vel 1 reload
DES-7200(config)# enable secret level 1 0 test
DES-7200(config)# end
E command and its subcommands:
D disable 1
D
at rel at a specific time/date
cancel cancel pending reload scheme
<cr>
The following s of
the command and all its sub-commands to the default value:
nal
% Unrecognized command.
command as “test”):
DES-7200# configure terminal
DES-7200(config)# privilege exec all le
nter the level 1, you can see the
ES-7200#
ES-7200> reload ?
oad
in reload after a time interval
is the configuration process that restores the privilege setting
reload
DES-7200# configure termi
DES-7200(config)# privilege exec all reset reload
DES-7200(config)# end
Enter the level 1, the privilege setting for the command is removed.
DES-7200# disable 1
DES-7200> reload ?
2-4