Filter
Top Products
DES-7200 Configuration Guide Chapter 4 802.1x Configuration
4-9
4.2.1 Default Configuration of
802.1x
The following table lists some defaults of the 802.1x
Item Default
Authentication DISABLE
Accounting DISABLE
Radius Server
*ServerIp
*Authentication UDP port
*Key
*No default
*1812
*No default
Accounting Server
*ServerIp
*Accounting UDP port
*No default
*1813
All port types
Uncontrolled port (all ports can perform
communication directly without authentication)
Timed re-authentication Off
Timed reauth_period 3,600 seconds
Interval between two authentication requests 10 seconds
Retransmission interval 3 seconds
Maximum retransmissions 3
Client timeout period
3 seconds, if within which no response is received
from the client, the communication is deemed as a
failure
Server timeout period
5 seconds, if within which no response is received
from the server, the communication is deemed as a
failure
Lists of authenticable hosts under a port No default
4.2.2 Precautions for
Configuring 802.1x
You can perform the following configuration only to the products that support 802.1x.
The 802.1x can run on both L2 device and L3 device.
It is required to configure the IP address of the authentication server before the
Radius-server authentication mode can operate normally.
You cannot enable 1X authentication on the 802.1Q TUNNEL port.