Filter
Top Products
DES-7200 Configuration Guide Chapter 9 MLD Snooping Configuration
9-16
Figure 1 MLD Snooping networking topology
Configuring Steps
Configuring Switch A (layer 3 switch)
# Enable layer 3 multicast
DES-7200#configure terminal
DES-7200(config)# ipv6 multicast-routing
DES-7200(config)# int vlan 14
DES-7200(config-if)# ipv6 pim sparse-mode
DES-7200(config-if)# ipv6 add 1111:1111::1111/64
DES-7200(config)# int gigabitEthernet 0/1
DES-7200(config-if)# no switch
DES-7200(config-if)# ipv6 pim sparse -mode
DES-7200(config-if)# ipv6 add 1111:2222::1111/64
# Configuring G0/4 as trunk port and its native vlan as SVGL vlan
DES-7200#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DES-7200(config)#interface gigabitEthernet 0/4
DES-7200(config-if)#sw trunk native vlan 14
Configuring Switch B ( layer 2 switch)
Configuring VLAN
# Configuring VLAN11
DES-7200#configure terminal
DES-7200(config)# vlan 11
DES-7200(config-vlan)#exit
DES-7200(config)#interface gigabitEthernet 0/1
DES-7200(config-if)#switchport access vlan 11
# Configuring VLAN12
DES-7200(config-if)#exit
DES-7200(config)# vlan 12
DES-7200(config-vlan)#exit
DES-7200(config)#interface gigabitEthernet 0/2
DES-7200(config-if)#switchport access vlan 12
# Configuring VLAN13