Filter
Top Products
DES-7200 Configuration Guide Chapter 10 Redundancy Configuration for Management
Module
10-8
10.2.2 Configuring the
Synchronization Mode
Run the following commands to configure the configuration files to be synchronized:
Command Function
DES-7200(config)# redundancy
Enter the redundancy configuration mode
DES-7200(config-red)# auto-sync
{standard | running-config |
startup-config}
Configure the configuration files to be
synchronized.
DES-7200#show running-config
Confirm the hot-backup started.
DES-7200#show redundancy state
Show the current redundancy operation mode.
10.2.3 Configuring the Heart-beat
Check Time
Run the following command to configure the heart-beat check time between the
master and the slave management modules.
Command Function
DES-7200(config)# redundancy
Enter the redundancy configuration mode
DES-7200(config-red)# switchover
timeout timerout-period
Control the heart-beat check time between the
master and slave boards
DES-7200#show running-config
Confirm the hot-backup started.
DES-7200#show redundancy state
Show the current redundancy operation mode.
10.2.4 Resetting the Management
Module
Run the following command to reset the specified the management module or both the
master and salve ones.
Command Function
DES-7200(config)#redundancy reload
{peer | shelf}
peer: reset the slave management module only.
shelf: reset both.