Filter
Top Products
DES-7200 Configuration Guide Chapter 4 802.1x Configuration
4-63
4.5.3.5 Verify Configurations
Step 1: If no reply is received after sending authentication request packets
(EAP-Request/Identity) for the configured number of tries, the user connected to the port will
automatically join VLAN10. The CLI will prompt:
%DOT1X-5-TRANS_DEFAULT_TO_GUEST: Transformed interface FastEthernet 0/1
from default-vlan 1 to guest-vlan 10 ok.
Step 2: The user downloads 802.1x client. After successful authentication, the CLI will prompt:
%DOT1X-4-TRANS_AUTHOR: Setting interface FastEthernet 0/1 author-vlan 2
succeeded.
1. Display the authentication state information of current user:
DES-7200#show dot1x summary
ID MAC Interface VLAN Auth-State Backend-State
Port-Status User-Type
-------- -------------- --------- ---- --------------- -------------
----------- ---------
8 00d0.f864.6909 Fa0/1 2 Authenticated Idle Authed
static
Step 2: Display detailed information about authenticated user.
DES-7200#show dot1x user id 8
User name: st
User id: 8
Type: static
Mac address is 00d0.f864.6909
Vlan id is 2
Access from port Fa0/1
Time online: 0days 0h 4m25s
User ip address is 192.168.201.56
Max user number on this port is 6000
Authorization vlan is 2
Authorization session time is 20736000 seconds
Supplicant is private
Start accounting
Permit proxy user
Permit dial user
IP privilege is 0
user acl-name st_1_0_0 :