Filter
Top Products
DES-7200 Configuration Guide Chapter 3 TACACS+ Configuration
3-6
server ip-address
Configure the server addresses in TACACS+
group server.
ip vrf forwarding vrf-name
Configure vrf name used in TACACS+ group
server (this command exits on the device
supporting VRF.)
tacacs-server host ip-address
[port integer] [timeout integer] key
[0 | 7] string
Configure IP address of remote TACACS+
security server; configures different parameters
on this server by different parameter combination:
z ip-address :configures server address;
z port intege [optional] :determines the port
used by the server; By default , the port number is
49 with the range from 1 to 65535.
z timeout integer [optional] :configures server
timeout time; By default, the timeout time is 5s
with the range from 1 to 1000s.
z key string [optional]:configures the key
shared with the server of corresponding ip.
tacacs-server key [0 | 7] string
Configure the shared key used to communicate
between the device and TACACS+ server. If the
corresponding host does not set key by itself, you
should set it globally.
tacacs-server timeout seconds
Specify the waiting time before the device
resends request. By default, it is 5s. if the
specified host does not set the specified timeout
time, you should set the time globally.
tacacs-server directed-request
[restricted] [no-truncate]
Configure the function of supporting the user
specified authentication server. The default
configuration is enabled.
Ip tacacs source-interface interface
Specify to send tacacs+ request to the source IP
used by the server. By default, it does not specify.
Caution
You must configure TACACS+ Key before configuring
TACACS+. The shared passwords on the network device and
TACACS+ server must be consistent.