Filter
Top Products
DES-7200 Configuration Guide Chapter 1 IP Address and Service
Configuration
1-14
recorded route, which are defined in RFC 791. If one of these options is enabled,
the device performs appropriate action. Otherwise, it sends an ICMP error
message to the source and then discards the packet. Our product supports IP
source routing by default.
To enable IP source routing, execute the following command in the interface
configuration mode:
Command Function
DES-7200(config)# ip
source-route
Enable IP source routing.
DES-7200(config)# no ip
source-route
Disable IP source routing.
Note
For DES-7200 series, due to the limitation of the hardware chip,
the command trap ip option packet shall be used to notify the
hardware of sending the packets with optional items to the
software for handling.