Filter
Top Products
DES-7200 Configuration Guide Chapter 1 Protocol-Independent
Configuration
1-8
Command Function
DES-7200(config-route-map)# set origin
{egp | igp | incomplete}
Set the route origin attribute.
DES-7200(config-route-map)#set
originator-id ip-addr
Set the route originator id.
DES-7200(config-route-map)# set tag tag
Set the tag value for the route
redistribution.
For different route-map applications, the results of the match and set command
are different. To make the user know whether the match and set command is
appropriate for the current application or not, DES-7200 provides the user the
message in the following circumstances:
When associating the route-map command, check the appropriateness of the
match and set command configuration in the route-map and the current
associated application. If it is not appropriate, the message prompts.
When configuring the route-map, match or set command, check the
appropriateness of all applications associated with the route-map and the match
and set command configuration in the route-map. If it is not appropriate, the
message prompts.
1.3 Route Redistribution
1.3.1 Configuring Route Redistribution
To support the routers to run multiple routing protocol processes, DES-7200
product provides the function for redistributing the route information from one
routing process to another routing process. For example, you can redistribute the
routes in the OSPF routing area to the RIP routing area , or those in the RIP
routing area to the OSPF routing area. Routes can be redistributed among all the
IP routing protocols.
In route redistribution, the route maps are often used to enforce conditional
control over the mutual route redistribution between two routers.
To redistribute routes from one routing area to another and control route
redistribution, execute the following commands in the routing process
configuration mode:
Command Function