Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Basic Switch Management
Configuration
If the corresponding main program does not exist when running
boot system command, the length and
the show
modification time of the file is also
Note
shown as N/A.
2.15.6 Configuration Example
The following example shows how to boot from the firmware.bin under the root
directory in FL
ASH, and how to boot from backup firmware_bak.bin when
t main program.
he main program flash;/firmware.bin with
can be skipped.
e
er or
2: configure the backup main program.
priority of backup main program should be slightly lower than the active
7200(config)# boot system flash:
an run the show boot system command to view confiugration.
200# show boot system
=====================================================
Size Modified Name
------------------- ------------------
1
3
7
======================================================
firmware.bin is damaged or lost.
Step 1: Configure the defaul
DES-7200(config)# boot system 5 flash:/firmware.bin
Since the device is cnfigured with t
priority of 5 during intialization, this step
Generally, it is recommended to set the priority of active main program to b
medium so that you can flexibly configure other main program with high
r priroity in future.
lowe
Step
The
main program.
8 /firmware_bak.bin
DES-
Step 3 Verify configuration.
You c
DES-7
Boot system config:
Prio
---- ---------
2
4
5 3205120 2008-08-26 05:22:46 flash:/firmware.bin
6
8 3205120 2008-08-26 05:25:09 flash:/firmware_bak.bin
9
10
2-25