Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Configuring BGP IP VPN
2-88
DES-7200(config-router)# network 192.168.20.0 255.255.255.0 area 0
DES-7200(config-router)# redistribute bgp subnets
DES-7200(config-router)# exit
DES-7200(config)# router ospf 20 VPNB
DES-7200(config-router)# network 192.168.10.0 255.255.255.0 area 0
DES-7200(config-router)# redistribute bgp subnets
DES-7200(config-router)# exit
DES-7200(config)# router bgp 1
DES-7200(config-router)# address-family ipv4 vrf VPNA
DES-7200(config-router-af)# redistribute ospf 10
DES-7200(config-router-af)# exit
DES-7200(config-router)# address-family ipv4 vrf VPNB
DES-7200(config-router-af)# redistribute ospf 20
DES-7200(config-router-af)# exit
# Configure the MPLS signaling on the backbone network and enable MPLS on the public
network interface.
DES-7200# configure terminal
DES-7200(config)# mpls ip
DES-7200(config)# mpls router ldp
DES-7200(config-mpls-router)# ldp router-id interface loopback 0 force
DES-7200(config-mpls-router)# exit
DES-7200(config)# interface gigabitethernet 1/1
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-GigabitEthernet 1/1)# no switchport
DES-7200(config-if-GigabitEthernet 1/1)# ip address 172.168.30.2 255.255.255.0
DES-7200(config-if-GigabitEthernet 1/1)# label-switching
DES-7200(config-if-GigabitEthernet 1/1)# mpls ip
DES-7200(config-if-GigabitEthernet 1/1)# end
# Configure routing protocols on the backbone network.
DES-7200# configure terminal
DES-7200(config)# router ospf 1
DES-7200(config-router)# network 172.168.30.0 0.0.0.255 area 0
DES-7200(config-router)# network 172.168.0.2 0.0.0.0 area 0
DES-7200(config-router)# end
PE3: