Filter
Top Products
DES-7200 Configuration Guide Chapter 2 Configuring BGP IP VPN
2-120
DES-7200(config-mpls-router)# ldp router-id interface loopback 0 force
DES-7200(config-mpls-router)# exit
DES-7200(config)# interface gigabitethernet 1/1
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-Gigabitethernet 1/1)# no switchport
DES-7200(config-if-Gigabitethernet 1/1)#ip address 10.10.10.2
255.255.255.0
DES-7200(config-if-Gigabitethernet 1/1)# label-switching
DES-7200(config-if-Gigabitethernet 1/1)# mpls ip
DES-7200(config-if-Gigabitethernet 1/1)# end
# Run OSPF on the backbone network to transmit routing information.
DES-7200# configure terminal
DES-7200(config)# router ospf 10
DES-7200(config-router)# network 10.10.10.0 0.0.0.255 area 0
DES-7200(config-router)# network 3.3.3.3 0.0.0.0 area 0
DES-7200(config-router)# end
# Assign an IP address to the interface connected to ASBR2.
DES-7200(config)# interface gigabitethernet 1/0
# The no switchport command is used to switch the port mode on switches to routed port mode.
It is not applicable to routers. You are not required to run this command on routers.
DES-7200(config-if-GigabitEthernet 1/0)# no switchport
DES-7200(config-if-gigabitethernet 1/0)# ip address 30.30.30.1
255.255.255.0
# Enable label switching on an interface.
DES-7200(config-if-gigabitethernet 1/0)# label-switching
The configurations of ASBR2 and ASBR3 are similar to that of ASBR1.